Owner's Manual

Table Of Contents

Bronze Series2

Amp Panel & Controls

1. RCA Stereo Inputs (Left & Right)

This is the method of signal input when using a stereo ampliﬁer system, connection can be provided

by a pair of high-quality signal cables from the pre-out section of an ampliﬁer. The crossover frequency

will need to be set if using this method of connection. If using the Bronze Series speakers set the

crossover dial to approximately 80Hz. This may vary depending on room and tastes.

Note: cable lengths should not exceed 10 metres to avoid interference from other electrical

appliances.

2. LFE Input (RCA Type)

This input is to be used when connecting the subwoofer to an AV ampliﬁer/ receiver. When using the LFE

input, the crossover frequency dial is not used. This is due to the crossover function being controlled by

the AV ampliﬁer/ processor to which it is connected.

3. 12 Volt Trigger Input ~ Centre Pin = +12Vdc

For external power control from AV ampliﬁer/ receiver to the Bronze W10. Monitor Audio recommend

using this function and a lead is supplied. A 12 volt signal is supplied by the AV amp/receiver and tells

the Bronze W10 to turn on from standby mode. This allows a more accurately controlled auto on/off

function, and is far more energy efﬁcient. When using the 12v trigger, the Mode Switch (8) can be in

either position, for it to function correctly.

4. Crossover Frequency Control

The crossover frequency control only operates when using the RCA stereo input (1) and is used to

set the upper frequency limit (low pass) of the subwoofer. The crossover control should be set in

accordance with the size or bass output of the main/satellite speakers. When using the Bronze Series

speakers, set this to between 50 - 100Hz (depending on additional speakers). Experimentation is

advisable.

5. Volume Control

This control allows the level or volume to be adjusted in order to achieve a balanced overall sound. To

get the balanced sound a selection of familiar music or ﬁlm excerpts will need to be played. Start with

the volume at minimum and increase the level control until a balanced sound is established.

If using an AV processor or AV receiver ampliﬁer, the system can be adjusted by the test tone function

within the set-up features. (Refer to the set up section in the AV processor or AV receiver ampliﬁer

4 5 6

7 8

10a