Instruction Manual

MicroShockDetector plus
- 6 -
1.4 E N V I R O N M E N T A L A N D S A F E T Y I N S T R U C T I O N S
Intended use
The MONILOG
®
MicroShockDetector plus is intended for the verification of transport and storage
conditions and may only be used under the operating conditions mentioned in the Section 2. No
safety-relevant functions may be derived from it.
Changes or modifications to the device could void the user's authority to operate the device.
The following information on handling lithium battery cells must be observed.
Environment & disposal
Der MONILOG
®
MicroShockDetector plus contains, excluding the lithium battery cells, no corrosive
or environmentally damaging substances.
Used lithium battery cells must be immediately removed from the device and be disposed of in an
environmentally friendly manner, according to the applicable legislation. Lithium battery cells are
hazardous waste.
Battery cell operation
The power supply in the MONILOG
®
MicroShockDetector plus is realized by one exchangeable
lithium battery cell (type AA|LR6) 3,6 V 2500 mAh. This can be bought in specialised stores or
from equipment suppliers. Due to the lithium cell used, the transport regulation UN3091-PI970 must
be observed during transport.
Operation with 1.5 V battery cells is not possible.
ATTENTION!
Risk of explosion if the battery cell is replaced with the wrong type.
Only use battery cells that conform to UN 38.3, IEC 60086-4 and
IEC 60079-11 (intrinsically safe).
In case of non-compliance with the national regulations/laws applicable in the handling of
lithium battery cells, any liability and warranty claims become void!
ATTENTION!
When transporting several devices or lithium battery cells in one package, this must be marked in
accordance with the transport regulation UN3091-PI970.
Decommissioning
In case of decommissioning the devices must be properly switched off and all battery cells must be
removed from the cases and be disposed of in an environmentally friendly manner.