Instruction Manual

MicroShockDetector plus
- 28 -
Figure 20: Overview of acceleration progress
4 . 3 . 8 C o n f i g u r a t i o n o f t h e M i c r o S h o c k D e t e c t o r s p l u s
To configure a device, use the “Configuration” tab (Figure 21) and adapt the parameters to the
upcoming transport. If a device is connected via USB, you can transfer all parameters to the
MONILOG
®
MicroShockDetector plus by clicking the “Send configuration” button.
Figure 21: Configuration of a device
The meaning of the available parameters is explained in section 4.3.2. In addition, the status
flashing of the device can be activated by ticking the box. When activated, the STATUS LED of the
device lights up briefly every 2 seconds and shows the active operating status. Alternatively, instead
of the STATUS LED the ALARM LED might light up red briefly ever 2 seconds, if a set alarm threshold
has been exceeded. The status flashing affects the remaining device runtime.