Instruction Manual

MicroShockDetector plus
- 18 -
4 . 2 . 2 F i l e a r e a
The data read from the device via USB can be saved on a data carrier using the icon or “Save
file” menu. Please note that the measurement data is only contained in the file if it was previously
read out via . Otherwise only the status data are included.
Figure 4: File area
Likewise, saved data can be fed again into the PC programme. The button “Open file” opens
the corresponding dialogue for the selection of the file.
4 . 2 . 3 M e s s a g e w i n d o w ( L o g )
The message window, which can be found as a programme tab “Log”, renders possible an
overview on the actions performed by means of the programme or the status changes of the device
during the established USB connection. Error messages and notes, e.g. for executing configuration
commands, connection establishment to devices, saving of data etc. are listed here.
Figure 5: Log-window
4 . 2 . 4 V i e w o f t h e m e a s u r e m e n t d a t a
As described above, the measurement data must either be read out from a connected device or be
available in an open file. The data can be displayed as a chart or a table.
Graphs