Instruction Manual

MicroShockDetector plus
- 17 -
4.2 G E N E R A L U S E O F T H E P C S O F T W A R E
4 . 2 . 1 E s t a b l i s h i n g t h e d e v i c e c o n n e c t i o n
When the device driver is installed and a device is connected via USB, the connection will be
established automatically as a rule upon start of the evaluation software.
If the evaluation programme has already been active before plugging the device or if you want to
connect a device to a different COM port, select the device via the USB menu at the top right.
In case of connection problems:
If no connection can be established to the device, select the
Refresh button (blue double arrow) and disconnect the USB cable from the device. Afterwards,
reconnect it with the USB cable.
Figure 2: USB connection window: currently connected to COM23
After a successful USB connection, the measurement data is read and then the status data of the
connected device is displayed:
Figure 3 Status view