Instruction Manual

MicroShockDetector plus
- 16 -
4. P C SO F TW A R E – M O N I L O G
®
AN A L Y Z E R
The software MONILOG
®
Analyzer can be used both for the readout and configuration of the
MONILOG
®
MicroShockDetector plus and other MONILOG
®
devices. It is intended for the display
and analysis of the recorded data in tabular and graphic form. Furthermore, data sets can be saved
locally on your PC or loaded from your PC.
4.1 I N S T A L L A T I O N
4 . 1 . 1 G e n e r a l s o f t w a r e i n s t a l l a t i o n
The supplied USB stick contains the installation of the MONILOG
®
Analyzer software, the driver for
the USB interface and documentation. Please start the installation by double-clicking on the file
„setup.exe“, and follow the instructions.
Note:
To install the software and the USB driver you need administrator rights on the PC.
4 . 1 . 2 U S B d r i v e r
When connecting a MONILOG
®
MicroShockDetector plus for the first time, it may be necessary to
install a USB driver on the PC. The “FTDI CDM Driver” is located on the supplied USB stick and is
set up with the software installation if it is not already available on the PC.
Now connect the MONILOG
®
MicroShockDetector plus to your PC using the USB cable supplied.
When the device is connected, the green STATUS LED lights up. After the LED has gone out, USB
is ready for operation and you can read out the device with the MONILOG
®
Analyzer software.