User Manual
Adjustments 4
27
27
Figure 4.11
Adjusng the Handlebar Alignment
❶ Using a 14 mm open-end wrench loosen the stem binder
bolt. Figure 4.11
❷ Move the handlebar le or right unl it is aligned with the
front wheel.
❸ Tighten the stem binder bolt. Check the handlebar binder
bolts to be sure they are properly ghtened and the
handlebar is clamped in place.
Adjusng the Handlebar Angle
❹ Loosen all of the handlebar binder bolts to allow the
handlebar to move.
❺ Rotate the handlebar to the desired angle. Be sure that the
handlebar stays centered in the handlebar bracket.
❻ Using a hex wrench, ghten the handlebar binder bolts a
lile at a me. Ensure the gap between the stem cap and
stem stays even.
❼ Repeat ghtening each handlebar binder bolt a lile bit unl
handlebar is secure.
Handlebar
binder bolts
Stem binder bolt
1
2
5
1