User Manual

4 Adjustments
24
Figure 4.7
Figure 4.6
If the gap between the brake pad and wheel is uneven,
adjust the posion of the brake pad. Figure 4.6
Loosen the nut on the back of the brake.
Squeeze the brake and hold the brake lever closed, while
re-ghtening the lock nut on the back of the brake.
Note: Watch the brake, if it begins to shi or rotate, then
release the brake lever, and use your hand to rotate the
brake caliper back unl both sides of the brake move
equally. Somemes it is necessary to over rotate the brake
slightly, so that as you ghten the locknut, the brake will
end up centered.
Pull and release the brake lever a few mes and check if the
pads are centered.
If necessary, repeat steps one and two unl the brake pads
are centered and the gap between the pads and rim is close
to 1/8 inch. Figure 4.7
Distance from
brake pad to
wheel rim is
1/8 inch
Axle nut
Brake pad
Wheel rim
Tire
Brake pad
lock nut
Locknut on
brake pad