User Manual

3 Assembly
18
Figure 3.8
Figure 3.9
ATTACH THE FRONT WHEEL
Loosen the axle nuts on the front wheel. If there is a washer
inside of the axle nut, it belongs outside of the fork
dropouts.
Posion the front wheel between the front fork legs with
the axle resng inside the fork drop out. Figure 3.8
Important! Be sure the wheel is as centered as possible
between the fork legs.
Place the clip retaining washer on the axle and slide it up
against the fork drop out. Make sure the hooked end is
inside the small hole of the fork dropout. Figure 3.9
Place the two outer axle nuts on and ghten evenly. Tighten
one side part way, then ghten the other side and repeat
unl both sides are ghtened securely. Be sure that the
wheel remained centered between the fork legs.
If it is o center, loosen the axle nut on the side that has a
smaller gap between re and fork leg and use your hand to
push the wheel to a centered posion; hold the wheel with
one hand and ghten the axle nut and check again. Repeat if
needed to be sure the wheel is centered and securely
ghtened.
Axle nut
Clip retaining
washer
Dropout hole
Axle
Fork dropout
Clip retaining
washer inserted
into dropout hole
3
3
2
3
4
4