User Manual
3 Assembly
14
Figure 3.3
ATTACH THE HANDLEBAR
❶ Turn the front fork to face forward. Figure 3.3
❷ Insert the handlebar assembly into the handlebar bracket
with the brake levers on the outside. Align the handlebar so
it is centered with the front wheel.
❸ Place the handlebar clamp plate over the handlebar,
aligning the holes in the plate with the holes in the
handlebar bracket.
❹ Insert the handlebar binder bolts (4 total) through the plate.
Using at 6 mm hex wrench, ghten the bolts.
❺ Using a 14 mm open-end wrench, ghten the stem binder
bolt at the top of the stem post. Check the handlebar binder
bolt(s) to be sure they are properly ghtened and the
handlebar is clamped in place.
WARNING!
• Improper aachment of the handlebar may result in
damage to the stem post, steering tube and result in lose of
control, serious injury or death. Ensure the minimum
inseron marks on the stem post are not visible above the
top of the headset.
• Failure to properly ghten handlebar components may
result in lose of control, serious injury or death. Always
check the handlebar cannot move and is secured to the
frame before riding the scooter.
❻ Look at all the cables to be sure they run in a smooth arc
from the brake lever to the front brake or cable stop on the
frame. Important! If they are twisted or kinked, braking will
not work.
Note: See Secon 4: Adjusng the Handlebar if adjustments
are needed.
Front fork
facing forward
Handlebar
binder bolts
Handlebar clamp
plate
Stem binder bolt
1
5
3
4
Handlebar bracket
2
6