Owner's manual

Assembly 3
27
27
Figure 3.19
MicroAdjustSeatwithPillarSeatPost
❶ Place the boom plate on the pillar seat post. Be sure the
holes in the boom plate and the holes in the seat post are
aligned. Figure 3.19
❷ Place the washer on the hex bolt and insert the bolt through
the boom hole of the pillar seat post and boom plate.
❸ Place the rails of seat into the grooves of the boom plate.
❹ Place the top plate over the top of the seat rails. The hex
bolt should be inserted through the hole in the top plate.
❺ Insert the square nut onto the hex bolt and ghten
completely.
❻ Insert the pillar seat post into the seat tube and adjust the
seat height up or down unl the rider feels they have
control of the bicycle and is comfortable.
Important! Be sure the minimum inseron marks do not go
past the top of the seat clamp and are not visible. See
Secon 1, Fig. 1.2: Seat Height and Handlebar Reach.
❼ Lock the seat in place. Note: Refer to the secon that
pertains to your seat clamping device (bolted or quick-
release) on the previous page for instrucons.
❽ Check the seat to be sure it does not move.
Quick-release
seat clamp
Bolted seat
clamp
Boom plate
Top plate
Square nut
Pillar seat
post
Seat rails
5
4
1
3
7
2
6
6