Owner's manual

3 Assembly

Figure 3.12

Figure 3.11

ATTACH THE FRONT WHEEL

There are two types of front wheel assemblies; nued and

quick-release. Note: Quick-release wheels may be on both the

front and rear wheels or just one. Also, some re tread paerns

have a direcon, so compare your front re and rear re of the

bicycle so that both tread paerns face the same way.

NuedFrontWheel

❶Posion the front wheel between the front fork legs with

the axle resng inside the fork drop outs. Note: If the front

wheel has a disc brake insert the disc rotor into the slot on

the caliper body as you insert the wheel axle into the fork

drop out. Important! Be sure the wheel is as centered as

possible between the fork legs. Figure 3.11

❷ Place the axle washers on the axle and slide it up against the

fork drop out.

❸ Aach the two axle nuts on the axle. Tighten one nut part

way, then ghten the other nut. Repeat unl both sides are

ghtened securely. Be sure that the wheel is centered

between the fork legs.

❹ If the wheel is o center, loosen the axle nut on the side that

has a smaller gap between re and fork leg and use your

hand to push the wheel to a centered posion; hold the

wheel with one hand and ghten the axle nut and check

again. Repeat if needed to be sure the wheel is centered

and securely ghtened.

Axle

Fork

dropout

Axle nut

Axle

washer

Disc rotor

Nut

Disc brake

caliper body