User Manual

Assembly 3

Figure 3.16

Note: Not all bicycles will accept training wheels. If your bicycle

did not come stock with training wheels, please call Pacic Cycle

to help determine if aer-market training wheels can be

aached.

There are three dierent braces used to aach the training

wheels to the bicycle: the c-shape brace, the at brace and the

at brace with stabilizer. Determine which brace was included

with your bicycle and follow the instrucons below.

C-ShapeBrace

❶ Remove the outer axle nut and washer from the rear wheel

axle. Figure 3.16

❷ Place the brace stabilizer washer onto the axle and align the

washer so that the notch on the washer ts into the frame

drop out.

❸ Place the C-shaped wheel brace onto the axle.

ATTACH THE TRAINING WHEELS

Failure to properly assemble and set up the training wheels

may cause instability and p over resulng in serious injury or

death. Always check the training wheels before using the

bicycle.

❹ Replace the washer and axle nut. Tighten the axle nut

securely, making sure that the wheel brace stays in the

proper vercal posion.

❺ The elongated hole on the wheel brace allows the training

wheel height to be adjusted for proper t.

WARNING!

Brace stabilizer washer

C-shaped wheel brace

Axle nut

Training wheel

Rear wheel axle

Inner axle nut

DO NOT REMOVE!

Washer