User Manual

Assembly 3

Figure 3.33Figure 3.32

ATTACHTHEPEGS

Important! Periodically check to make sure pegs are ght.

Some models may come equipped with 2 or 4 pegs.

To install pegs:

❶ Do not loosen or remove axle nuts.

❷ Check to make sure axle nuts are properly ghtened before

installing pegs.

❸ Thread the pegs on the axle over the axle nut. Figure 3.32

❹ Insert a screwdriver or similar tool through the peg holes

and ghten by turning the peg with the tool. Figure 3.33

DeepSocketPegs

❺ Remove one of the axle nuts with the ratchet; then remove

any remaining washers.

❻ Screw on the axle adapter washer if needed. When the pegs

are larger than the axle, a special washer is needed so that

the pegs t properly. If your pegs and axle are the same size,

skip this step.

❼ Insert an-roll pins into the peg so that the pegs remain

staonary while performing tricks. Screw the pin ghtly,

using an Allen wrench.

❽ Slide the peg over the axle; secure the an-roll pin and

loosely ghten with the deep-well socket.

❾ Ensure there is no fricon between the wheel and the chain

stays and brake pads. Adjust the wheel if necessary so that

all parts work freely. Once parts are in working order, use

the deep-well socket to ghten the axle nut.

Peg

Axle nut