Installation Instructions

Fold the 9" flap under the starting edge.
Press Mongoose Ridge Vent to the roof, the
glue will hold Mongoose Ridge Vent to the
roof shingles.
Installation Instructions:
1.
Cap seal
material
Venting material
9" end cap flap
Roll out Mongoose Ridge Vent along ridge line of roof.
There is a center line on Mongoose Ridge Vent to help
you align the material with the center of the ridge. Press
Mongoose Ridge Vent to the roof so that the glue strips
adhere to the roof shingles.
2.
When the ridge length is greater than 20'
or you are using leftovers from a previous
job, you must create a joint to continue
the vent. To join two pieces together, one
piece must have a 9" flap and the other
must be flush. Butt the four vent strips
together and secure with caulk. Lap the
9" cap seal material over the joint using
a bead of caulk under the lap to create a
water-tight seal.
3.