Operator`s manual

34
Saw Chain
HOW TO BREAK IN A NEW CHAIN
The life of your new chain can be extended by taking
these few simple steps before using it.
▲ 1. Before the first use,
soak the chain overnight
to allow oil to penetrate
all chain components.
▲ 2.Run new chain at half throttle for several minutes
before doing any cutting in order to allow oil to
reach all parts of the bar and chain. Let sprocket,
bar, and chain warm up fully.
■ 3. Stop, let the chain cool, then check and
▲ adjust tension often (especially
during the first half-hour of use)
as shown on pages 18-21.
Keep the first several
cuts light. Keep extra
oil on the bar and chain
during these first cuts, and
do not apply heavy pressure.
 Never run any chain on an overworn drive
sprocket, especially a new chain.
◆ Replace drive sprocket systems after every two
chains, or sooner. See page 91.
NOTES
Basic Break-In Tasks
▲ Before use ■ Often ● Daily ◆ Weekly  Never
25436_Txt_2005.qxd 9/20/2004 12:15 PM Page 34