Operator`s manual

Saw Chain

3. The area where depth-gauge filing occurs on

Vanguard chain is identified by a witness mark. Do

not file outside the witness mark and do not round

off Vanguard depth gauges after lowering them.

3. Always file Vanguard depth gauges from the

nnssiiddee

oouutt..

HOW TO INSTALL NEW CHAIN PARTS

READ THE WARNING ON PAGE 17.

Use only new Oregon

parts to repair Oregon

chain. And only use parts which are the

correct size and type for your chain.

1. Remove rivets, and parts to be replaced, as

shown under “How to Break Out Rivets,” pages

32-33. Never reassemble a chain with old preset

tie straps –

always use new preset tie straps.

2. If needed, file off the bottom of new parts to match

existing worn parts. File new cutters back to match

worn cutters. Do not file the tops of kickback-reduc-

ing bumper tie straps or bumper drive links (except

on 33-34-35SL chains, see page 39).

NOTE

CONTINUED...

25436_Txt_2005.qxd 9/20/2004 12:15 PM Page 30