VFI Series User's Manual

VFI33 Vent Free Gas Fireplace System
20307670
27
LOG PLACEMENT
INSTALL 18", (F,R) HIGHLAND OAK LOGS ON NAT-
URAL BLAZE BURNER (AVAILABLE FOR MAJESTIC
SYSTEMS ONLY)
1. Place the #1 log (the “chunk”) on the grate bar right side
of the burner adjacent to the controls. Figure 33
Figure 33
Ember Chunk
Log #1
3. Place right rear log (#3) on pin located on rear support
bracket and rest left side of log on front right log. Figure
34. After placing right rear log, ensure log is fully upright
and does not tilt forward. Slide #1 log ember chunk back
to contact right rear log.
2. Place front right log (#2) on right pin located on burner
and right grate bar. Figure 34. After placing front right
log, ensure log is fully upright and tilting towards the
back of the burner.
Right Front
Log #2
Figure 37
Figure 36
Left Rear
Log #4
Figure 35
Right Rear
Log #3
4. Place left rear log (#4) on pin located on rear support
bracket on left side and left grate bar. Figure 36
Figure 34
5. Place left front log (#5) on left pin located on burner and
left grate bar. Rest top right portion of log on right front
log. Figure 37
Left Front
Log #5