Owner's Manual
3
General Installation Information
The new LSTF36-B is a vent free rebox. It features a self
contained heat circulating system.
This installation manual will enable you to obtain a safe,
efcient and dependable installation of this vent free re-
place system.
Do not alter or modify the rebox or its components under
any circumstances. Any modication or alteration of the
rebox system, including but not limited to the rebox and
accessories, may void the warranty, listings and approvals
of this system and could result in an unsafe and potentially
dangerous installation.
BEFORE YOU START
Carefully inspect the contents for shipping damage. If any
parts are missing or damaged, immediately inform the
dealer from whom you purchased the appliance. Do not
attempt to install any part of the appliance unless you have
all the parts in good condition.
Note: If using a blower or light kit, electrical
connections should be made prior to the rebox being
enclosed by the nished walls.
MAKE SURE YOU HAVE RECEIVED ALL
PARTS
Verify contents to ensure all parts have been received.
The following should be included:
1. Vent Free Gas Firebox
2. Canopy (2)
3. Installation and Operating Instructions
WHAT YOU WILL NEED FOR INSTALLATION
TOOLS and BUILDING SUPPLIES
• Phillips screwdriver • Square
• Framing materials • Hammer
• Saw and / or saber saw • Tee joint
• Level • Pipe wrench
• Measuring tape • Pliers
• Electric drill and bits
• Fireplace surround materials (noncombustible)
• Caulking material (noncombustible)
• Wall nishing materials
• Piping complying with local codes
• Pipe sealant approved for use with propane/L.P.G.
(resistant to sulfur compounds)
Refer to the installation instructions provided with the log
sets for items required for log set installation.
10
Monessen • LSTF36-B Installation and Operating Manual • 4613-900 • Rev B • 10/19