Operating instructions

GETTING STARTED

Make sure you have received all parts:

Check your packing list to verify that all listed parts have been received. You should have the following:

•Unvented gas log grate/burner assembly.

• Installation/operating instructions.

• Ceramic fiber logs.

•Two (2) anchoring screws.

• Plastic bag containing crushed volcanic rock.

Millivolt controlled heater designed to be operated with optional devices for ON/OFF functions.

• Hand held Remote w/receiver.

•Wall Switch with 20' wire.

•Wall T-stat with 20' wire.

• Hand Held Thermostat Remote w/receiver

Carefully inspect the contents for shipping damage. If any parts are missing or damaged, immediately

inform the dealer from whom you purchased the appliance. Do not attempt to install any part of the

appliance unless you have all parts in good condition.

What you will need for installation:

You must have the following items available before proceeding with installation:

• External regulator (for propane/L.P.G. only)

• Piping which complies with local codes

• Pipe sealant approved for use with propane/L.P.G. (Resistant to sulfur compounds)

•Manual shutoff valve

• Sediment trap

•Tee joint

• Pipe wrench

• Screwdriver

• Drill, with 5/32 bit

Handle the gas log burner assembly by the grate only. Do not pick the unit up

by the burners.

Gloves are recommended when handling ceramic fiber logs to prevent skin

irritation from loose fibers. Logs are fragile--handle with care.

CAUTION