Instruction manual

Danger: Do not install this
heater in any area where
gasoline or any combustible or
explosive material will be used
or stored. The flame from this
heater is exposed to the area
around the heater. Contact with
explosive or flammable
materials will lead to explosion
or fire.
SELECTING A LOCATION
5
These heaters are shipped from the factory equipped for mounting on a
flat wall. A wall-mount template is provided with each heater to aid in
locating the heater on a wall. Maintaining at least the minimum spacing
to combustibles as illustrated by Figure 1 is required for safety. Using
the wall-mount template will help ensure that the required minimum
clearances between the heater and adjacent walls, floor, and ceiling are
maintained when mounting the heater on a wall.
The wall-mount anchors provided with each heater are for mounting the
heater to a hollow wall (wall area between studs.) If the heater is to be
mounted to a solid wall such as concrete or masonry, these wall-mount
anchors should not be used. Obtain appropriate solid wall-mount anchors
with number 10 mounting screws from your local hardware store.
The minimum clearances (see Figure 1) between combustible materials
and a wall mounted heater are:
Back - 0 inches (mount directly on wall).
Floor - 3 inches
Sides - 12 inches on one side of the heater;
18 inches on the opposite side of the heater.
Top - 36 inches
Front - 48 inches
36" MIN.
36" MIN.
(SEE NOTE 2 )
(SEE NOTE 2 )
18" MIN.
18" MIN.
(SEE NOTES
(SEE NOTES
1 &2 )
1 &2 )
12" MIN.
12" MIN.
(SEE NOTES
(SEE NOTES
1 &2 )
1 &2 )
NOTES:
NOTES:
1. THE 12" MINIMUM AND 18" 
1. THE 12" MINIMUM AND 18" 
MINIMUM DIMENSIONS
MINIMUM DIMENSIONS
FROM HEATER SIDES TO
FROM HEATER SIDES TO
COMBUSTIBLES MAY BE 
COMBUSTIBLES MAY BE 
REVERSED IF NECESSARY.
REVERSED IF NECESSARY.
2. WALL MOUNTED HEATER
2. WALL MOUNTED HEATER
SHOWN. UNLESS NOTED
SHOWN. UNLESS NOTED
OTHERWISE, ALL CLEARANCE
 OTHERWISE, ALL CLEARANCE 
DIMENSIONS SHOWN ALSO 
DIMENSIONS SHOWN ALSO 
APPLY TO A HEATER MOUNTED
APPLY TO A HEATER MOUNTED
ON A FLOOR STAND.
ON A FLOOR STAND.
3. GAS PIPING NOT SHOWN.
3. GAS PIPING NOT SHOWN.
(SEE NOTE 2)
(SEE NOTE 2)
IN FRONT OF HEATER.
IN FRONT OF HEATER.
MATERIAL CLOSER THAN 48 INCHES
MATERIAL CLOSER THAN 48 INCHES
DO NOT PLACE COMBUSTIBLE
DO NOT PLACE COMBUSTIBLE
SIDE WALL
SIDE WALL
OR OTHER
OR OTHER
COMBUSTIBLE
COMBUSTIBLE
SURFACE
SURFACE
SIDE WALL
SIDE WALL
OR OTHER
OR OTHER
COMBUSTIBLE
COMBUSTIBLE
SURFACE
SURFACE
3"
3"
MINIMUM TO TOP SURFACE OF
MINIMUM TO TOP SURFACE OF
CARPETING, TILE OR OTHER
CARPETING, TILE OR OTHER
COMBUSTIBLE MATERIAL.
COMBUSTIBLE MATERIAL.
(APPLIES TO ALL WALL MOUNTED HEATERS ONLY)
(APPLIES TO ALL WALL MOUNTED HEATERS ONLY)
CEILING LINE OR OTHER
CEILING LINE OR OTHER
COMBUSTIBLE SURFACE
COMBUSTIBLE SURFACE
FIGURE 1
53D9012. Rev 1 03/03