Instruction manual

LIGHTING AND OPERATING HEATER

PILOT

ALTERNATE METHOD OF LIGHTING THE PILOT WITH A MATCH

Follow the steps as if you were going to light the pilot with the push button i

gnitor up to the point 

of pushing down on the control knob to initiate the flow of gas to the pilot. 

Then:

1. Position yourself where you are not directly in front of the heater and will

be able to simultaneously reach 

the pilot with a burning match and push down on the control knob. (To reach

the pilot easier, use a long fire place

the pilot easier, use a long fire place 

style match.)

2. Place a burning match at the end of the pilot barrel as shown below and push

the control knob down fully.



3. After the pilot is lit, continue to hold the control knob down for a minute a

nd then release it. The control knob

should pop back up fully and the pilot should remain lit.

 If the control knob does not pop up when released, stop and immediately call you

If the control knob does not pop up when released, stop and immediately call you

r service

 technician or gas supplier.

 If the pilot will not stay lit after several tries, turn the gas control knob cl

If the pilot will not stay lit after several tries, turn the gas control knob cl

ockwise to "OFF"

 and call your service technician or gas supplier. 

and call your service technician or gas supplier. 

4. Return to Step 7 of the Lighting Instructions on the previous page of this ma

nual.



TO TURN OFF THE HEATER - Turn the control knob clockwise to OFF. The k

nob will click 

between Pilot and OFF.



FOR COMPLETE SHUTDOWN - Turn the control knob clockwise to OFF

OF THE HEATER and turn the shutoff valve off. (See Figur

es 2 & 3.)

53D9012. Rev 1 03/03