Operating instructions
38
20304164
ICFDV Fireplace Insert
LG1122
ICFDV log flame
Make sure the gas valve knob is in the “OFF” position. Wait at least ve (5) minutes before
start-ing maintenance.
A qualied agency should examine the venting system annually.
Clean the ceramic glass periodically. Condensation will sometimes form on the glass during a
cold startup. This is normal for all gas replaces and inserts. This condensation often attracts
dust and lint to the surface of the glass. The initial paint curing of the appliance can also leave
a slight lm on the glass. This is a temporary problem.
You should clean the glass after the rst two weeks of use. After that, you should clean the
glass no more than two or three times a season. Use a mild glass cleaner to clean the door.
Do not use abrasive cleaners. They will damage the glass surface.
Visually check pilot and burner ames periodically. Refer to Figure 46 for typical burner ame.
Refer to Figure 47 for typical pilot ame.
Figure 46 -
Typical Burner Flame
LG1122
Figure 47 -
Typical Pilot Flame
FP2453
hooded pilot flames
Sensor
Thermopile
FP2453