Operating instructions
20304164
ICFDV Fireplace Insert
13
FP2979
intake exhaust
The intake/exhaust manifold is shipped attached to insert. It may
be removed to allow tight installation.
1. Unfasten the two (2) machine screws on the face of the unit
and release the plate assembly by sliding the plate back.
2. Attach the exhaust and the intake ex pipes to the collar on
the plates with a hose clamp (not provided) or other approved
methods (check local codes).
3. Re-attach exhaust bafe and manifold assembly in reverse
order of Step 1.
Figure 9
Machine
Screws
Intake Collar
Exhaust/Intake
Slide Plate
Assembly
FP2979
Exhaust Collar
The unit is shipped from the factory as a natural gas unit
with the bafe installed. The bafe should be sufcient for
venting up to 20 feet (6 m) off the top of the unit. An extra
bafe plate is shipped with the unit for installations 20
feet and above. Adjust the plate to the closed position as
desired. Figure 10
FP1961
baffle adjustment
9/08
Loosen Four (4) Screws to Adjust
FP1961
Figure 10 -
Bafe Assembly and Adjustment