Operating instructions

38
42D0200
Designer Series Gas Fireplaces
 
Make sure the gas valve knob is in the “OFF” position. Wait at least ve (5) minutes before start-
ing maintenance. Fireplace must be cold before starting maintenance.

A qualied agency should examine the venting system annually.

Clean the tempered glass periodically. Condensation will some-
times form on the glass during a cold startup. This is normal for all
gas replaces. This condensation often attracts dust and lint to the
surface of the glass. The initial paint curing of the appliance can also leave a slight lm on the
glass.
Your should clean the glass after the rst two weeks of use. After that, you should clean the
glass no more than two or three times a season. Use a mild glass cleaner to clean the door. Do
not use abrasive cleaners. They will damage the glass surface.


1. Carefully remove log set, and embers (rock wool) from
combustion chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum or brush with soft brush any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct
positions. Refer to Pages 34 through 36.
6. Replace door (if it has been removed).
7. Relight pilot. Refer to Page 37.
8. Turn on main burner.




LG645
DV6000 log flames
Figure 50 -
Typical Burner Flame
LG645
Figure 51 -
Typical Pilot Flame
Thermopile
Thermocouple
FP2312
pilot flame
FP2312
Visually check pilot and burner ames periodically. Refer
to Figure 50 for typical burner ame. Refer to Figure 51 for
typical pilot ame.

    
    



