Operating instructions

12
42D0200
Designer Series Gas Fireplaces


The appliance is shipped as a rear vent unit. If the installa-
tion layout requires the unit to be a top vent conguration
the appliance can be converted by following the steps
below.
When removing and retting the plates and adapter be
sure the associated gaskets are undamaged and retted
as required.

    


 B\,    

FP1991
remove screws
Screws
Flue Pipe
Adapter
Flue Pipe
Adapter
FP1991
Figure 10 -
Remove 16 Screws from Flue Pipe
Adapter and Flue Pipe Cover
FP1992
remove flue pipe
Screws
Flue Pipe
FP1992
Figure 11 -
Remove Flue Pipe
Flue Pipe
Cover
FP1993
replace flue pipe
Screws
Flue Pipe
FP1993
Figure 12 -
Attach Flue Pipe to Top Vent Coln-
guration
1. Remove the eight (8) screws securing the ue pipe
adapter to the replace body. Figure 10
2. Set the ue pipe adapter aside, complete with the
gasket. Do not damage the gaskets as the adapter and
gasket must be retted.
3. Remove the eight (8) screws securing the ue pipe cover
to the top of the intake box and remove the cover and
gasket. Figure 10
4. Remove eight (8) screws securing the ue pipe to the
back of the intake box and remove the pipe and gasket.
Figure 11
5. Replace ue pipe to top of rebox. Ensure the gasket is
in place and undamaged. Secure with eight (8) screws.
Figure 12
6. Place the ue pipe cover and gasket removed in step
3 over the ue opening in bottom of the intake box.
7. Ret the ue pipe adapter and gasket to the top of re-
place. Secure the adapter with eight (8) screws removed
in step 1.