Specifications

Equipment details
54
Equipment details
55
waterowsfreelyfromthetap.
Note: If only the cold water system is being
used, the heater tank will also fill with water.
In order to avoid damage through frost, the
water heater must be drained as detailed in
the following paragraph.
Draining the water heater
WARNING: The water may be hot and
cause scalding.
1. Disconnect the water pump and switch off
power supply where appropriate.
2. Open all hot and cold water taps.
3. Open safety/drain valve and leave in
vertical position, position (f).
4. The water heater will drain directly to the
outside. Check that the water contents
have been completely drained (10 litres).
GAS OPERATING INSTRUCTIONS
Attention: Do not operate the water heater
without water in it!
Removethecowlcoverpriortousingthe
water heater.
Switching On:
1. Removecowlcover.
2. Open gas cylinder and open quick-acting
valve in the gas supply line.
3. Select required water temperature with the
inner rotary knob (b) (infinitely variable from
approx. 30ºC to 70ºC).
4. Switch on water heater by turning outer
rotarycontrol(a)totheamesymbol.A
green indicator light will illuminate.
Fig. 2
5. If there is air in the gas supply line, it may
take up to a minute before the gas is
available for combustion. If the appliance
switches to ‘Failure’ during this period.
switch off the appliance - wait 5 minutes -
and switch on again!
Switching Off:
Turn the outer rotary control (a) to 0.
Drain the water heater if there is risk of frost!
If the heater is not to be used for a long period,
the cowl cover must be fitted to ensure that
the appliance function is not impaired by the
ingress of water, dirt or insects. Failure to fit the
cowl may invalidate the warranty.
Turn off the gas supply at the cylinder.
ELECTRICAL OPERATING INSTRUCTIONS
Attention: Do not operate the water heater
without water in it!
PresstheswitchonthefusedspurtoON.
The indicator lamp indicates that the heater is
switched on.
Note: Under electrical operation, the water
temperature cannot be selected. The
temperature is automatically limited to 70ºC.
For faster heating up period the appliance
can be simultaneously operated with gas.
Fig. 3
Maintenance
The water heater should be serviced annually
during the routine vehicle service.
The instructions covering fitted equipment to
your vehicle were correct at the time of going
to print. Owners handbooks are updated
annually and we take great care to try and
ensure their accuracy. However, the Swift
Group Limited cannot accept responsibility
for any changes that may be made in
specification or operating instructions to the
equipment described in this section after the
time of going to press.
Every care is taken to ensure that the
information provided in this handbook is
correct and easy to understand.
Separatemanufacturers’leaetsonmany
of the components are also included in the
Owner’s Pack provided with this vehicle
and we recommend that you compare
the instructions in the handbook with
the component manufacturers literature,
to ensure the information provided is as
accurate as possible.
If you are in any doubt as to how to operate
the equipment in your vehicle, please contact
the component manufacturer’s service
department on the telephone number shown
ontheircomponentleaet.Ifyouremainin
any doubt, please contact the Swift Group
Supercare customer care service department
on 01482 875740.
Equipment Specification
For details on type of equipment fitted in
yourvehicle,pleaserefertotheSalesBrochure
or Dealer.
IMPORTANT
To maximise the use and life of all fitted
equipment in your vehicle it is essential that
any accompanying manufacturers’ literature is
read fully. All recommended maintenance and
preparation procedures should be followed.
The information provided in this handbook is
only intended as a guide. If in any doubt consult
your manufacturer appointed dealer, particularly
before attempting to install
EXTRAEQUIPMENT.
NOTICE:Intheinterestofsafety,
replacement parts for an appliance shall
conform to the appliance manufacturer’s
specifications and should be fitted by them
or their authorised agent.
TRUMA ULTRA-STORE
WATER HEATER
The water heater features a system that
will heat water using liquid petroleum gas
or 230V mains electricity. The heater can
be simultaneously operated on gas and
electricity to give a faster warm-up period.
The cassette has a capacity of 10 Iitres.
Attention: Always fit the cowl cap when
the water heater is not being operated!
Drain the water heater if there is risk of
frost and preferably when you leave the
site. Leave all taps open. Frost damage is
not covered by the warranty!
Filling the Truma-Ultrastore with water
1. Check that the safety/drain valve in the cold
water intake is closed. Lever should be in
horizontal position, position (e) Fig. 1.
Fig. 1
e = Lever position
‘Closed’
f = Lever position
‘Drain’
2. Open hot tap in bathroom or kitchen; set
pre-selecting mixing taps or single lever
fittings to ‘hot’.
3. Switch on power for water pump. Leave the
tap open to let air escape while the water
heater is filling. The heater is full when