Specifications

Electrical systems
50
Electrical systems
51
GENERATOR GUIDELINES
Your motorhome can be used with a generator
provided these guidelines are met:
• Lackofregularservicingcanbethecause
of most generator problems, gensets under
2kW are mainly dependent on engine
speed for output frequency and voltage.
Poor or no servicing may cause the engine
speed governor to run the genset to fast.
Therefore, frequency and output voltage
can rise above the specification of the
machinedataplatei.e.230Vat50Hz.This
may cause damage to electrical/electronic
equipment (such as battery chargers).
• Ageneratorshouldalwaysrunforafew
minutes prior to connection with the
motorhome electrics, to allow it to warm up
and the output to settle to a steady level.
• TheACoutputofgeneratorsisoften
derived from an AC alternator, rectified to
DC then inverted back to AC. In essence
this means the output sinewave may not
run sophisticated electronics efficiently.
Some of the new wave of gensets are
more sophisticated in their production of a
sinewave output and are more suited to run
electronic equipment.
• Ifindoubtconsultyourgensetdealeror
manufacturer for advice.
The Display will automatically return to the
Clock Screen after approximately 2 minutes if it
is left on this Screen.
WASTE ALARM SCREEN
WA STE FULL
When the Waste Water Tank is full then the
WASTEALARMSCREENwillbedisplayed
and the Display will beep, to clear this fault
the Waste Water Tank must be emptied or the
CentreButtonmustbepressed.IftheDisplay
is pressed but the Tank is not emptied then the
Alarm Screen fault will be shown again after 10
minutes approx. This will continue until the Tank
is emptied.
The audible side of the Alarms are turned off
between the hours of 8pm and 8am. If the
Screen is not pressed then it will continue to
displaytheaboveandtheScreenwillBeepand
changecolourfromBluetoRed.
FRESH WATER ALARM SCREEN
WhentheWaterTankisemptythentheFRESH
WATERALARMSCREENwillbedisplayedand
the Display will beep, to clear this fault the Fresh
WaterTankmustbelledortheCentreButton
must be pressed. If the Display is pressed but
the Tank is not filled then the Alarm Screen fault
will be shown again after 10 minutes approx.
This will continue until the Tank is filled.
WAT ER LEVEL
LOW
The audible side of the Alarms are turned off
between the hours of 8pm and 8am. If the
Screen is not pressed then it will continue to
displaytheaboveandtheScreenwillBeepand
changecolourfromBluetoRed.
12V CHARGER & DISTRIBUTION BOARD
12V FUSE IDENTIFICATION
FUSE 1
Brown 10A Slate = front roof lights
Brown 10A Pink = rear roof lights
Brown 10A Yellow-white = 12v sockets
Brown 7.5A
Purple = toilet / internal
pump
Brown 10A
Black-red & black-green
= omnivents / heater / hob
ign
Brown-
green
15A Red-yellow = fridge
Brown-
green
20A Brown-green = step
Brown-
green
5A Brown-green = alarm /
display / relay windings
FUSE 8