Installation Guide

Adjustable wrench
Philips Screwdriver
Tools You Will Need :
Hexagon Wrench
Kitchen Faucet Installation
Pipe Tape
60-100MM
weight here
2.3''~3.9''
Step6:
Tightening the supply hoses and
separate them to the pull-down
hose in case that the sensor
doesn't work.( Tighten with a
wrench until secure ).
Step5:
Install the weight near the end
of the pull-down hose (The
optimal place is about 2.3-3.9
inches from the lowest of the
pull-down hose).
Step8:
Open the angle valve and the
handle to make the water flow.
Check for the connections
whether leak. If leaking, please
re-tighten.
Step7:
Remove spray head from spray
hose. Hold tip of spray hose.
Turn faucet on and let the water
run for 60 seconds to flush any
debris.
HOT
COLD
HOT
COLD
Step2:
Put the gaskets and steel
washer and nut in sequence
through the hose.
Step1:
Get all hoses through the deck
plate and the sink hole.
Step3:
Then tighten the screws.
Step4:
Connect spray hose to quick
connector attached to supply line.
Notes before installation
1.Please check that all components are presdent
2.Before installation ensure that all feed lines are clear of
debris and on/off valve is present
3.Ensure water pressure is between 20-125 PSI
(includes combination of hot and cold feed lines)
4.Pictures in the manual are general inccontent and may
not represent exactly your purchased faucet .if you are
having difficulties please contact a professional plumber
5.If you will be away from home for an extended period you
should shut off the main water supply.
Daily maintenance
1.Use a soft cloth and vinegar to remove hard-water spots.
2.Check aerator (if present) regularly for calciumbuild up are
when water stream is not optimum
3.DO NOT use caustic cleaning products as the use will break
down finish and will void the product warranty.
4.Acceptable cleaners include vinegar or mild non-abrasive
liquid detergents.
5.If the water pressure appears to be less than optimum,
remove,inspect,clean or replace aerator.
HOT
COLD