Installation Guide

Installation steps

8. Insert the spout to the pipe whlch outslde the wall,then

tighten the screw.

9. Install the shower arm,shower head and flange to the

fitting. (stick to the wall) .Tighten the showerhead to the

shower arm with the pipe tape.( Make sure the

7. Warp the thread of spout with teflon tape (ensure it

must warp clockwise).Screw-in to the inlet pipeinside

the wall, then install the decorative cover on the wall

clingy.

Installation steps

1. Confirm the installed place of the pressure balance

valve and fixed on the wood block .

2. Connect the hot&cold inlet tube and outlet tube,then

make sure the tube fix stable on the wooden wall.

3. Lock the install protective cover into the body. (

155*100mm oval type).

4.Please cut the size of the tile

hole according to the size and

shape of the protetived cover

( about 5mm bigger than the

protetived cover from each side )

. And please put the tile outside

the wooden wall ( please noted

that wekeep the same central

point for the tile hole with the

protetived cover ) .

5. Loosen the screw and remove protect cover.

6.Lock the deck plate into the body and cling to the wall.

Put on the handle, then tight the screw.

Installation steps