User manual

2
3
1
4
2
3
1
4
LC7TT novo
13
Monark novo Contol Unit
Connection to external control unit
No tests can be performed at Monark novo display
unit, then you must connect your bike to a PC, via
the Monark novo control unit, and use a special test
software. A suitable one is available to download
from our website: www.monarkexercise.se.
The bike do not need to be switched off when connecting
external components, but it is recommended, to
prevent transmission of incorrect data.
Be careful when connecting different types of external
devices to prevent flash-over and subsequent injury.
The user must ensure that the correct cables are used,
otherwise you risk serious injury or damage on the
device.
Connect external device via RS232
Make sure the power adaptor is connected to the bike
Turn off the power switch on the bike.
The RS232 port is located on Monark novo control
unit behind the left side front cover. Connect the
RS232 first to Monark novo control unit in the bike
and then to the external device. Set the bike power
switch to "on" and then start the external device.
Connect external device via USB
On LC7 TT novo the USB-B port is located on
Monark novo control unit behind the left side front
cover. Open the front cover to access Monark novo
control unit. You can pass the cable you want to
connect through the cable inlet in the left side cover.
Remember to lock the cable in the strain relief.
The side cover is
transparent in the gure
Fig: Connections
1) RS232 port
2) USB-Bport
3) Strain relief
4) Cable inlet