User manual

1
2
1
2
LC7TT novo
12
Shifters on the handlebar
The workload can be regulated via the shifters on the
handlebars. The basic principle is that you change
in large steps on the left side and in small steps on
the right side. How big stages is set in Monark Test
Software (MTS). In MTS, you can also change if you
prefer to adjust the workload with large steps on the
right side or small steps on the left side instead.
The different workload units (sets in MTS) you can
use are:
• Power (Watt)
• Brake force (Kp)
• Torque (Nm)
Watt is RPM independent and Kp and Nm are RPM
dependent.
RIght side shifter
On a regular cycle the shifter on the right side controls
the rear derailleur. If you press (1) you switch down
and the workload increases. If you press (2) you
switch up and the workload decreases.
Left side shifter
On a regular cycle the shifter on the left side controls
the front derailleur. If you press (1) you switch down
and the workload decreases. If you press (2) you
switch up and the workload increases.
Fig: Left side shifter
1) ”Down” gear
2) ”Up” gear
Fig: Right side shifter
1) ”Down” gear
2) ”Up” gear