Troubleshooting guide

16
8
4
2
16
8
4
2
Metro/Puls
RPM
3
1
1
Monark 831 E
7
Fig: Rpm display
Height adjustment of table stand
The height of the table stand can be adjusted to get
the ergometer at the desired level by using the crank
at the stand. To adjust the height on the table stand,
pull out the crank and crank it until the desired height
is reached. To lock the table stand, push the crank
again. See fig: Table stand.
Initial operation
Although all 831 E ergometers are 100 % calibrated
at the factory, the user may wish to verify this
by performing the mechanical calibration of the
pendulum weight. See section ”Calibration of
Pendulum Weight”.
Apply power to the ergometer by first connecting the
cable from the power adaptor to the ergometer at
the front connector labelled “24VAC/18VAC“. Then
plug the power adaptor into the wall outlet. Turn
the power switch to “On”-position. A green LED
indicates power to the 831 E.
Perform the electrical calibration as specified in section
”Electronic calibration”.
Test run the ergometer. The Ergometer 831 E is now
fully functional and ready to use.
RPM Display and Visual Metronome/Pulse
The metronome (the two green LED bars in the
middle) flashes once per handle stroke at a preset rate.
The two green LED bars in the middle can also be set
to show pulse. It makes one flash for every heart beat.
Crank handle frequency compared to metronome rate
is always shown.
Underspeed:
Crank handle speed is lower than desired metronome
rate. 2, 4, 8, 16 or more depending on which LED bar
that indicates.
Overspeed:
Crank handle speed is greater than desired metronome
rate. 2, 4, 8, 16 or more depending on which LED bar
that indicates.
Fig: Table stand
Height adjustable crank (1)