Troubleshooting guide

16
8
4
2
16
8
4
2
Metro/Puls
RPM
1
2
3
Monark 839 E
7
Cycle adjustments
Do not forget to remove the transport protections
(the transportation bracket on the weight lever, the
protection tape on the flywheel and the transport
blocks above and below the flywheel).
Seat height should be adjusted to a comfortable
position. The appropriate height is to have the knee
slightly bent when the sole of the foot is centred over
the pedal axle with the pedal to the bottom position.
To adjust the seat height loosen the lever(1) on the
seat tube. See Fig: Adjustments.
The handlebar setting should be in a comfortable
position when cycling. During longer exercise sessions
it is recommended to occasionally change handlebar
position. To adjust the handlebar, loosen the quick
release lever(2). See Fig: Adjustments.
NOTE! The handlebar stem should be inserted into
the frame tube at least 3 inches (about 8 cm). This
measure is marked with “MAX” on the stem(3).
Initial operation
The ergometer 839 E is to 100 % calibrated at the
factory. The user may wish to verify this by performing
the mechanical calibration of the pendulum weight.
See ”Electronic calibration”.
Apply power to the ergometer by first connecting the
cable from the power adaptor to the ergometer at the
front connector labelled "24VDC / 18VAC". Then
plug the power adaptor into the wall outlet. Turn the
power switch to on position. A green LED indicates
power to the 839 E.
Perform the electrical calibration as specified in section
"Calibration Electronics”. Test ride the ergometer.
The 839 E Ergometer is now fully functional and
ready to use.
Fig: Adjustments
1) Quick release bolt
2) Quick release lever
3) Inserted min. 3”
Fig: RPM display
min. 8 cm
(3”)
Rpm Meter and visual Metronome / Puls
The metronome (the two green LED bars in the middle)
flashes once per pedal stroke at a preset rate. The two
green LED bars in the middle can also be set to show
pulse. Pedal frequency compared to metronome rate
is always shown.
Underspeed:
Pedal speed is lower than desired metronome rate
2, 4, 8, 16 or more depending which LED bar that
indicates.
Overspeed:
Pedal speed is greater than desired metronome rate
2, 4, 8, 16 or more depending which LED bar that
indicates.