Specifications

Monark Ergomedic 828 E

Operating Instruction

Workload device

The 828 E uses a brake belt system to control

the resistance. The brake power can be changed

by increasing or decreasing the tension of the

brake belt against the tension knob(1). See ﬁg:

Workload device.

Cycle adjustments

Seat height should be adjusted to a comfortable

position. A suitable height is when your knee is

slightly bent and the middle of the foot is straight

above the pedal axle with the pedal is in its lo-

west position. To adjust the seat height loosen the

lever on the seat tube. See ﬁg: Adjustments.

The handlebar setting shall give a comfortable

position when cycling. During longer exercise

sessions it is recommended to occasionally chan-

ge the handlebar position. To adjust the handle-

bar loosen the quick release lever. See ﬁg: Adjust-

ments.

NOTE! The handlebar stem should be inserted

into the frame tube at least 3 inches (about 8 cm).

this measure is marked out on the stem(3).

Fig: Workload device (1)

Fig: Adjustments

1) Lever, seat post

2) Lever, handlebar

3) Inserted min. 3”

min. 3”