Specifications

Monark Ergomedic 828 E
10
Service
Crank bearing
The crank bearing is long term greased and needs
normally no supplementary lubrication. If pro-
blem arises, please contact your Monark dealer.
Flywheel bearing
The bearings in the flywheel are lifetime greased
and require normally no maintenance. If problem
arises, please contact your Monark dealer.
Brake belt contact surface
The brake belt should be regularly checked to en-
sure that it has not suffered excessive wear. If it
looks worn it should be replaced. Deposits of dirt
on the brake belt and on the contact surface may
cause the unit to operate unevenly and will also
wear down the brake belt. The brake belt contact
of the flywheel surface should then be ground off
with fine sand paper and any dust removed with
a clean dry cloth.
Remove left cover. Set the tension device to mi-
nimum load/tension. Take off the brake belt to
the side. Grind with a fine sand paper. See fig:
Brake belt contact surface. Grinding is easier to
perform if a second individual cautiously and ca-
refully pedals the cycle.
Irregularities on the brake belt contact surface
are removed by means of a fine sand paper or an
abrasive cloth. Otherwise unnecessary wear on
the brake belt may occur and the unit can be-
come noisy.
Always keep the brake belt contact surface clean
and dry. No lubricant should be used. We recom-
mend to replacing the brake belt when cleaning
the contact surface. In regard to assembly and
adjustment of the brake belt, see ”Replacement
of brake belt”.
Fig: Brake belt contact surface