Specifications

Monark 828 E
7
Computer specifications
Computer Instruction
Press any button or move the pedal to turn on the
meter. At the display for heart rate (HR) a heart sym-
bol is lit which means that the meter is trying to find
a pulse signal from an external source (chestbelt with
electrodes, Art. No: 9339-98). If the meter can not
find the heart rate signal the HR-function is automati-
cally turned off after 30 seconds. When the function
is turned off the heart symbol is not lit any more. The
heart rate function can be turned on again by press-
ing a key.
The timer starts automatically when the pedals are
moved. Meter values for Time, Distance and Calories
can be set to zero by pressing the RESET-key for more
than two seconds. To get correct readings for calories
and watts, the kp-value on the electronic meter has to
be set to the same value as the pendulum, or the kp-
window shown to the left of the electronic meter.
Display
RPM 0 - 250 rev./min
HR 50 - 240 bpm
TIME 0:00-99:59 min:sec
SPEED 0 - 99 km/h or mph
DISTANCE 0.0 - 99.9 km or mile
FORCE 0.0 - 7.0 kp
CALORIES 0 - 999 kcal
WATT 0 - 7 x rpm watt
Batteries: 1.5 V x 2, R6 (AA)
Storing temperature: -10ºC - +60ºC
Operating temperature: 0ºC - 50ºC
Example: The pendulum and the kp-window is
showing 2 kp. Press the kp-key to the left on the
meter. The lower display window is now showing
figures in kp. Increase or decrease in steps of 0.1 kp
by pressing the kp-key - (arrow up) or the RESET-key
- (arrow down) until the reading corresponds with the
actual or desired kp-values on the pendulum scale or
in the kp-window. After that press the CAL/WATT-
button to either show the CAL- or WATT-figures.
The watt reading in the display is depending on the
pedalling speed. The watt reading can then be fine
tuned through increase or decrease of the pedalling
speed. Calories are calculated all the time.
Do not expose the electronic meter to direct sunlight
or extremely high temperature. Do not use any dis-
solvent when cleaning. Use only dry cloth.