Setup guide
9
I. Hardware Installation
Once all components are unpacked and the recommended connections and environment are
available, you are ready to start setting up your TriFIT 620.
Step 1
Plug one of the USB to USB cable ends into the USB connector on the back of the TriFIT
700iu box. If you are using a serial cable to connect the TriFIT 700iu box to your PC, then
plug the male end of the serial cable into the serial port of the 700iu box.
Step 2
Plug the other end of the USB to USB cable into a USB port of the PC or laptop. If you are
using the serial connector, plug the female end of the db-9 cable into an available 9-pin
serial port of your computer.
An optional Db-9 serial cable can be used
in place of the USB cable
If using the USB to USB connection,
then one end goes into the 700iu box
and one end
g
oes into the PC USB.