Setup guide

Step 5

Now you are ready to plug the testing devices into the TriFIT 700iu unit. They each have

unique connectors, so you cannot plug the wrong device into the wrong connector.

Step 6 –Platform Setup

• Attach the “C” connector on the strength strap

assembly to the strength handle. Make sure it is

tightened all the way.

• Check the strap for any wear or defects before

each use, as this could cause injury to the client

being tested on the Biceps Strength Test.

II. Optional Equipment Setup

Monark Bike

If a Monark 828E was purchased with your TriFIT 620 system, you will receive a Bike

interface cable. This cable plugs into the 700iu box where it is labeled bike and plugs into

the connector on the front cover of the Monark 828 Bike. Refer to the Instruction manual

that came with the Monark 828 for setup instructions. To calibrate the bike and setup

defaults for the TriFIT, see the next sections.

Bike interface

plug on the

Monark 828

Bike or Heart

Rate Cable

for Treadmill

goes here

Load

Platform/Scale

goes here

Range of

Motion Unit

goes here

Skyndex or

Lange

calipers go

here

Bike interface

Plug on 700iu

box