Instruction manual

Fig 4
Before the handlebar stem is assembled be sure the
expanding wedge is loose. Insert the handlebar stem
into the frame tube and tighten the expanding bolt
firmly by means of the lever.
NOTE: The handlebar stem should be inserted
into the frame tube at least 7.5 cm (about 3
inches). See fig. 4.
Usually this measure is marked out.
To change the height of the handlebar, loosen the
expanding bolt about 5 mm. Give the bolt a light push
to release the expanding wedge. Adjust the handlebar
to the desired position and tighten the expanding bolt
again by means of the lever.
In order to change the inclination of the handlebar,
loosen the expanding bolt one turn. Adjust to desired
angle of handlebar and tighten the expanding bolt/
lever firmly again.
8
7.5 cm