Installation & Assembly

INCLUDED;
A. Top hat shaped pure copper gutter reducer
B. Brass Bolt with groove in middle to hang
rain chain with threaded ends on both sides
C. 2 pcs of Brass Dome Nuts
Step 1: Unscrew the 2 brass nuts from the
bolt (Figure 1)
Step 2: Take your Rainchain, unhook Cross Bar or
Triangular Hanger from top link with slightly bending by
hand or with help of pliers. Cross Bar or Triangular
Hanger is not required when installing with a Gutter
Reducer (Figure 2)
Step 3: Slide in the brass bolt (B) inside the hole from the
inside circle of the gutter reducer(A) and push it out, place
the first link (top link) of rainchain in brass bolt, then slide
the other end through the 2nd hole and tighten both
nuts(C) at the open ends to make the installation secure
(Figure 3)
Step 4: Securely hang your rain chain from the center
groove of the bolt (Figure 4)
Installation Complete
Cross Bar Triangular Hanger
Or
Figure 4
Figure 3
GUTTER REDUCER
The pure copper gutter reducer is designed to fit in the rain gutter over the drain hole where there is a
downspout.
The wide mouth captures most of the rain water and tapers down (inverted top hat shape) to direct the
flow of water from the gutter into the rain chain.
Our pure copper gutter reducer © provides a seamless assembly between the rain chain and gutter.
Figure 2
Or
Gutter Reducer / Adaptor
Figure 1
A
B
C
C
INSTALLATION INSTRUCTIONS
Rain Chain Assembly With Gutter Reducer (Adaptor)
Rainchain