Instruction Manual

NOTE: The Full scale output settings must have been specified when

ordered or may be user programmed using the User

Programming Cable.

2.2.1 Current Output Option

The current output is 4 to 20 mA. This output is a current source

and has a 10 Vdc internal compliance voltage. The maximum load

that may be connected is 450 ohms.

Typical connections are as follows: (Shown

right)

Connections for current out are to the terminals

marked ANALOG OUT. Connect the Positive

side of the load to the terminal marked + and the

other side of the load to the terminal marked -.

2.2.2 Voltage Output Option

The voltage output is 0 to 5 Vdc.

Connections for voltage out are to the terminals

marked ANALOG OUT. Connect the Positive

side of the load to the terminal marked + and the

negative or common side of the load to the terminal marked -.

2.3 Sensor Input

The SENSOR INPUT is the input terminal used to connect an external

sensor or trigger source. There is a voltage output that may be used to

power an external sensor (5 or 12 Vdc – user selectable at 75mA max).

The system supports two wire inputs (Signal and Common) or three

wire sensors (Supply, Signal and Common). Three wire sensors can be

open collector types – NPN or PNP, TTL output or –ve output types.

5.0 SPECIFICATIONS

Input Range: 0.1 to 10 KHz, 5 to 600,000 RPM

Accuracy: 0.005%

mA Option: 4 to 20 mA out, 16 bit resolution 10Vdc compliance

voltage. Zero and full scale settings as specified when

ordered or user programmable using USB Programming

Cable and PM Remote Software

Vdc Option: 0 to 5 Vdc out, 5 mA 16 bit resolution. Zero and full

scale settings as specified when ordered or programmable

using USB Programming Cable and PM Remote Software

Resolution: 76 microvolts or 30.5 micro amps

Dimensions: L x W x H = 80 x 40 x 28 mm (3.2 x 1.6 x 1.2 inches)

excluding the mounting wings

Power Supply: 12 to 24Vdc +5% @ 150mA max

Input: TTL input or +3 Vac to +12 Vac

Sensor Supply: 5Vdc or 10 Vdc at 75 mA – User selectable

This product is CE certified and ROHS compatible.

Manufactured in an ISO9001 facility.

For troubleshooting information and technical support visit