User manual

115
4 & 8 & 16 Channel DVR Operation manual Revision 1.0
z You should do HDD JUMPER setting before or after HDD & BRACKET. This setting
methods are different according to HDD manufacturer.
z Generally you can find some setting information on the top of HDD, you can follows those
instructions.
z In case of one HDD installation, set HDD to ‘MASTER’ or ‘SINGLE’ .
z In case of two HDD, one HDD set to ‘MASTER’, the other HDD set to ‘SLAVE’.
z If you finish the installation of HDD& BRACKET, Put those finished HDD into DVR.
z You can do it as above drawing. Pay attention to the direction of HDD connector.
z Be careful of front panel cable might be stuck in HDD set and DVR.
z Volts can be used same ones when you disassembled.