Specifications

Security 2009
Important Information
RECORDERS · CAMERAS · VIDEO SPLITTERS · MONITORS · CCTV WIRELESS SYSTEMS · ACCESSORIES · ALARM
S 112
MONACOR INTERNATIONAL – Your reliable partner – all over Europe.
Important Notes – Please read very carefully!
All products of MONACOR INTERNATIONAL are tested continuously to ensure a constant quality level and to maintain the high quality standards. All products which are subject to
the CE guidelines as well as the electric and electronic subassemblies which are subject to the directive for motor vehicles, are tested to the respective standards and carry the CE mark.
In consequence, these products can be sold in all EC countries without further tests or approvals.
General Information
• All rights reserved by MONACOR INTERNATIONAL GmbH & Co. KG. All contents of the
catalogue serve as information as to the products by MONACOR INTERNATIONAL only. No part
of this catalogue including text, photos of products, graphics, or any parts thereof may be
reproduced in any form or by any means for any commercial use without our express prior written
consent.
• * Windows is a registered trademark of Microsoft Corporation in the United States and other
countries.
• We cannot be held responsible for printing error, should they occur.
• We reserve the right to make technical changes without prior notice.
• The technical specifications stated are according to the information of the manufacturer.
• Due to production tolerances technical data may vary slightly.
• Damage resulting from unauthorized servicing of the products thus causing changes, as well as
improper handling resulting in consequential damage are excluded from the warranty. We will
not be liable for changes of the state of the products resulting from improper storage, other
interventions or improper use.
• If the units are interfered with, the CE approval will no longer apply.
• All products are always suitable for indoor use only unless otherwise stated.
• The products do not correspond to the medical products directive 93/42EG.
• If the products are to be put out of operation definitively, they must be taken to a local recycling
plant for disposal which is not harmful to the environment.
Technical Information
• Before first use of the products please read the instruction manual carefully!
• The products correspond to the directive for electromagnetic compatibility 2004/108/EG and
partly to the low voltage directive 2006/95/EG and their amendments.
• When operating with voltages of over 42 V, please always observe the respective safety measures.
• Before opening any products operated with 230 V mains voltage, disconnect the products from
the supply voltage!
• Make sure that the supply voltage is disconnected before working on components and modules.
Existing capacitors must be discharged.
• Mains connecting cables and test cables have to be examined for damage regularly. Never pull
on the cable to disconnect the plug from the socket.
• Mains connecting cables and mains fuses must only be replaced by skilled personnel.
• Unless otherwise stated:
– protect the products from humidity and heat,
– always observe the admissible ambient temperature of 0–40 °C.
• Do not use a very high volume level when using headphones. Permanent high volume may
damage your hearing!
• A soldering process which is too long and too hot may cause damage to the corresponding
products. Choose a soldering temperature that is suitable for the material used. No liability can be
assumed for damage to the product or consequential damage caused by improper handling.
• The plugs, jacks, switches, rotary switches, and potentiometers shown in this catalogue are only
suitable for connection to safety extra low voltage (SELV) or signal voltage unless the item is
designed for a higher voltage (see text or table).
• If the fixing nuts of chassis mount jacks or chassis plugs are tightened too much, this may cause
damage to the whole component. In case of improper handling no liability can be assumed for this
or consequential damage.
• The heat must be eliminated by air circulation. Therefore do not cover ventilation slots with any -
thing. Do not put or drop anything through the ventilation slots. Otherwise there will be danger of
an electric shock.
• Only use a dry, soft cloth for cleaning the products. Chemicals must not be used in any case.
Information on the German Product Liability Act
According to the law dated December 15, 1989 governing
product liability which was last amended by the law dated July 19,
2002, manufacturers, importers, and dealers are obliged to
compensate for damage caused by a faulty product under certain
prerequisites.
A product can already be considered faulty if its presentation
leaves a private, non-commercial end user with a wrong impres-
sion as to its safety in use or if it is to be expected that the private
end user will not observe the required safety regulations when
using the product or will apply an excessive operating voltage to it,
except if this user has been informed as to the necessity to observe
the safety regulations and specified voltages, etc.
In your own interest and for your customers' safety, therefore
please draw your non-commercial customers' attention to the
following:
The products listed in this catalogue may only be used for the
stated purpose. If there are any doubts as to the purpose of the
goods, questions must be clarified with an authorized expert or
with the service department of MONACOR INTERNATIONAL.
The following EN standards and VDE (Verband Deutscher Elektro-
techniker = Association of German Electrical Engineers) regulations
must be observed:
Electromagnetic compatibility:
EN300422, EN301489, EN55013, EN55020,
EN61000-3-2, EN61000-3-3, EN61000-6-1, EN61000-6-3
Low voltage directive:
DINVDE0100, DINVDE0532,
EN60065, EN60742, EN60570, EN60335,
EN60598, EN60950, EN61010
Motor vehicles directive:
directive 72/245EWG, changed by the directive 2004/104/EG
In Germany, the above-mentioned regulations can be
obtained from:
VDE-Verlag GmbH VDE-Verlag GmbH
Bismarckstraße 33 Merianstraße 29
10625 Berlin • Germany 63069 Offenbach • Germany
Phone: [phone] Phone: [phone]
Fax: [phone] Fax: [phone]
Notes concerning approval of wireless systems
The systems have been examined by a notified body and have
been approved in the EU according to the R+TTE directive.
However, it is necessary to apply for a frequency assignment at the
national authorities. In Germany, the frequency assignment has to
be applied for at the corresponding branch of the Federal Network
Agency (BNetzA, Germany)
A license is required for these systems!
The wireless microphone systems in the frequency ranges from
790 MHz to 814 MHz (for Germany, please refer to ruling
91/2005), 863 MHz to 865 MHz are generally approved and
are licence-free!
The declaration of conformity can be found on our website:
www.imgstageline.de
The forms for the frequency assignment as well as the ruling
91/2005 can be found on the website of the Federal Network
Agency (BNetzA): www.bundesnetzagentur.de
For countries outside of Europe, please consult the corresponding
authorities of your country.
Please observe the notes in the operating instructions!