Instruction manual

36
RS-485 Communication Setting
Half Duplex
Full Duplex
The factory setting of RS-485 is Half-Duplex.
Note: Do not change the settings without the instructions of professional technicians.
1.3 IP Address
IP address can be adjusted by the arrow on the switch. For example, IP address is”123.”
Please adjust it with the order of Percentile (1), Decile (2) and Unit (3). Please see it as
following:
Percentile Decile Unit
(1) Please do not set up the identical IP address of two Speed Domes to avoid
communication collisions.
(2) While adjusting the IP address, please make sure “0(Zero)” is in the north.