Instruction manual

17
4.5【Save】Settings
4.5.1 When all above settings finished, if you want to save them as default value, you only need to push
“SAVE” button. When it’s done, the saved setting is permanent. Power failures of switching off do
not clear the default value.
4.5.2 When “SAVE” button is pressed, the LCD will be displayed in the following information.
S
a
v
e
.
.
.
.
.
.
.
.
.
O
K
4.6 Speed Dome Camera Settings
4.6.1 Each Speed Dome has the function of Auto-Image Tracing & Positioning which can be set up from
the main control unit. Each chairman/delegate unit could set up to16 Speed Domes which has 128
Programmable Preset Positions of each camera.
4.6.2 Press ”MODE” button  move “◘” to SPEED DOME SETTING mode（the 2
nd
page of the MENU）
（）ID code 001 displayed under MIC column  press ”UP” or ”DN” button  select the “ID code”
of microphone
5
◘
S
P
E
E
D
D
O
M
E
S
E
T
T
I
N
G
M
I
C
D
O
M
E
A
D
R
(
0
0
1
)
0
1
0
0
1
4.6.3 The conference system totally has 1,009 groups of ID codes.
4.6.3.1 ID code of delegate unit: 999 groups of numbers from 001 ~ 999
4.6.3.2 ID code of chairman unit: 10 groups of numbers from 1 ~ 10
4.6.4 When “ID code” of microphone has been selected  press ”STEP” button  move to right side to
ID code 001 under DOME column （）ID code 01 displayed under DOME column  press ”UP”
or ”DN” button  select the “ID code” of IP Speed Dome (See the Appendix – ID Codes of Speed
Dome camera)
5
◘
S
P
E
E
D
D
O
M
E
S
E
T
T
I
N
G
M
I
C
D
O
M
E
A
D
R
0
0
1
(
0
1
)
0
0
1
4.6.5 One main control unit can control 16 speed domes cameras. No. 01 ~ 16 is the” ID code” of these
16 speed dome cameras.
4.6.6 When “ID code” of speed dome has been selected  press ”STEP” button  move to right side to
ID code 001 under ADR column （）ID code 01 displayed under ADR column  press ”UP”
or ”DN” button  select the “Programmable Preset Positions” of Speed Dome.