Owner`s manual

87
2008 LAPALMA XL
APPLIANCES — 4
The motor home is divided into two
operating Zones: Living Room and Bedroom/
Bathroom. The comfort control must be in Zone
1 for the furnace to operate. Press the Zone
button to change zones. The selected zone will
ash. The line under the zone indicates that a
selected function is operating in that zone. The
UP or DOWN buttons control the temperature
in any mode. Remote temperature sensors are
located throughout the motorhome to ensure
accurate temperature control.
Wall Thermostat Requirements for
Operation:
Ensure house batteries are charged.
Ensure house battery disconnect is on.
Battery cut-off switch must be on.
Living Room = Zone 1
Bedroom/Bathroom = Zone 2
Remote temperature sensors are located
throughout the motorhome to ensure accurate
temperature control.



NOTE:
The Comfort Control must be ON to
operate any HVAC function. DO NOT
select conflicting modes of operation.
One zone cannot be on COOL while
another zone is set to FURNACE.
NOTE:
The motorhome will not heat or cool
faster by selecting a very high or very
low temperature setting.
aIr conDItIonIng - roof
The roof air conditioners operate from
120 Volts AC supplied by shore power or the
generator. The wall thermostat requires 12 Volt
DC to operate.
NOTE:
The air conditioning system freezes
moisture in the air. It is recommended
to set the blower fan speed to high
when operating in high humidity.
NOTE:
There are ambient air temperature
limitations in Heat Pump mode. The
roof air conditioner will not operate
in Heat Pump mode with ambient
temperatures of 30º F and below.
NOTE:
For detailed information and
operating instructions, refer to the air
conditioner OEM manual.
Operation
Operation Requirements:
120 Volts AC, from either shore power or
the generator, is supplied.
The battery cut-out switch is ON and the
house batteries are charged.
Fan Operation:
Circulates interior air by
using the roof air conditioner
blower. The fan speed controls
the roof air conditioner blower
speed in the following modes:
Fan, Cool or Heat Pump.
Press the MODE button
repeatedly until FAN is
displayed.
Press the FAN button to
select the desired fan speed.
Air Conditioner Operation:
Press the ZONE button to select Zone.
Press the MODE button repeatedly until
COOL is displayed.
Set desired fan speed by pressing the
FAN button.
Set desired cooling temperature by
pressing the UP or DOWN buttons.
NOTE:
The compressor will engage
approximately two minutes after
blower motor activation to prevent
accidental compressor operation
against high pressure.








Remote Temperature Sensor
030950c
050200k
050200e