Owner`s manual

ELECTRICAL SYSTEMS - HOUSE — 8
166
2008 LAPALMA XL
Incandescent Light
Incandescent lights come in different styles or
variations. The bulb inside the 12V incandescent
light is replaceable.
To Replace a Bulb:
1. Carefully squeeze the lens cover then
gently pull the cover out. The cover has
tabs that lock the cover in place.
2. Using a clean cloth or piece of tissue
carefully grasp the bulb and rotate to
the unlock position.
3. Remove bulb from the socket.
4. The bulb replacement is 1141 12V
21CP.
NOTE:
Replacement bulb number is accurate at
time of printing. Confirm replacement
bulb number before ordering or
obtaining a replacement.
5. Using a clean cloth or piece of tissue
grasp the new bulb and align the prongs
on the bulb with the slot on light
socket.
6. Push bulb in and rotate to lock position.
7. Gently squeeze lens cover and insert
tabs on cover into xture.
CAUTION:
DO NOT touch the incandescent bulbs
while it is on. Allow bulb to cool down
before replacing because a hot bulb can
cause a burn.
Bedroom/Map Light
Operation:
Turn the map light on by pressing the On/Off
switch on the map light. The map light pivots
left and right to allow illumination of different
areas.
In addition a wall switch is located next to the
bed which also turns the map light on/off. For
the wall switch to operate the On/Off switch on
the map light must be on.
To Replace a Bulb:
1. Carefully push in on the bulb and turn
counterclockwise.
2. Pull bulb from the socket.
3. Replace bulb. To re-install align the two
pins on the bulb with the two channels
on the socket. Insert the bulb and turn
clockwise.
If Map Lights Fail to Operate:
Ensure Battery Cut-Out switch is turned
on.
Check bedroom fuse panel and map light
fuse in roadside front electrical bay.
NOTE:
Confirm bulb number before ordering
or obtaining a replacement.


TABS
LENS
COVER
TAB
080475c
060326