Owner`s manual

165
2008 LAPALMA XL
ELECTRICAL SYSTEMS - HOUSE — 8
4. Carefully grasp bulb and pull from
socket. Replace with the same type and
wattage of bulb.
5. Use a clean cloth or piece of tissue to
grasp new bulb. DO NOT touch bulb
directly as this can cause a “hot spot”
and result in immediate bulb failure.
6. Align contacts of bulb with terminals in
xture base. Insert bulb until contacts
are rmly seated.
To Reinstall:
7. Align tabs on light lens with slots in
xture base. Rotate lens clockwise until
light lens locks into place.
8. Fold up both spring clips and insert
light xture into opening. Once in
opening the spring clips will expand
and lock light xture into place.
CAUTION:
DO NOT touch halogen lighting while
on. They can cause a burn. DO NOT
touch replacement bulbs. Oil in the
hands can cause a “hot-spot” to occur. If
the bulb is touched, allow it to cool and
clean the bulb with alcohol.
Fluorescent Light
Operation:
Turn the xture On/Off by pressing the power
switch on the side.
To Remove a Fluorescent Tube:
Make sure light xture is Off.
Carefully squeeze both sides of lens
cover. The cover has a groove on each
side that ts into a guide rail. Remove
lens cover.
Grasp the uorescent tube with both
hands and rotate so that the prongs are
facing straight up in the socket slot.
Carefully remove tube.
Replace with Philips TL 8W/33T
uorescent tube
NOTE:
Replacement tube number is accurate
at the time of printing. Confirm
replacement tube number before
ordering or obtaining replacement.
To Replace a Fluorescent Tube:
Align the prongs on the uorescent tube
with socket slot.
Insert tube and using both hands rotate to
seat.
WARNING:
Fluorescent bulb must be fully seated for
proper operation.







Insert one groove on the lens cover into
the guide rail.
Carefully squeeze lens cover to insert
other groove into guide rail.
CAUTION:
DO NOT touch fluorescent tubes while
they are on. Make sure tubes are cool
before handling.


060336