Owner`s manual

EQUIPMENT — 5
104
2008 LAPALMA XL
Manual Override - Main Slide Room
To Manually Move the Main Slide Room:
1. Turn off both the battery and house
disconnect switches.
2. Locate the living room slide-out
motor near the ceiling of the slide-out.
Remove the trim.
3. Disconnect the slide-out motor
electrical plug, located by following
wires that run from the motor to the
plug. This removes 12 Volt DC power
from the slide-out motor.
4. Attach the exible shaft and adapter to
the tting on the end of the slide-out
motor.
5. Attach a socket and ratchet or drill to
the other end of the exible shaft.
6. Turn in proper direction to move the
room. If the cables tighten and the
motor is difcult to turn, reverse
direction. Over-torquing can result in
severe damage.
7. Take motorhome to an authorized repair
center.
Manual Override - Bedroom
Depending on oorplan, the bedroom may
have either a cable or an above oor slide-out
system. The above oor slide-out is used when
the bed moves with the slide out. If the closet
moves with the slide-out, the system is cable.
Another method of checking for the cable
system is with bedroom slide-out extended a
cable is visible under the slide-out.
To Move the Bedroom Slide Room (Above
Floor System) Manually:
1. Turn off both the battery and house
disconnect switches.
2. The above oor
slide-out
motor is
located
under the
bed. Lift
the bed and
remove the
access panel.
3. Disconnect
the slide-out
motor electrical plug to remove 12 Volt
DC power from the slide-out motor.
The plug can be located by following
wires that run from the motor to the
plug.
4. Use a wrench to turn driveshaft and
retract room.
5. Once the slide room has been manually
retracted, apply pressure to the wrench
to rmly set the room. This will prevent
room drift.
6. Take the motorhome to an authorized
repair center.
CAUTION:
DO NOT continue to turn the motor
after the room is fully extended
or retracted. Damage to the slide
mechanism can occur.
To Move the Bedroom Slide Room (Cable
System) Manually:
1. Turn off both the battery and house
disconnect switches.
2. Locate the bedroom slide-out motor.
The motor is located near the ceiling of
the slide-out. Remove the trim.
3. Disconnect the slide-out motor
electrical plug to remove 12 Volt DC
power from the slide-out motor. The
plug can be located by following wires
that run from the motor to the plug.
4. Attach the exible shaft to the tting on
the end of the slide-out motor.
5. Attach a socket and ratchet or drill to
the other end of the exible shaft.
030750c
031277d
031277e